It there anyway to auto discover hosts within Host Monitor or import an ping response list from IP-Tools. Or even use the ping response list to scan for ports or netbios in IP-Tools.
If this is possible can it be automated so new servers can be automatically picked up.
Any help appreciated.
Rex
Auto discovery
Rex,
There are some "auto discover" options.
- when you setup Ping or TCP test a range of IP addresses (e.g. 123.123.123.1 - 123.123.123.254) rather than a single address can be specified. In this case, HostMonitor will create a separate test for each of the addresses within that range. After 1st check you may remove all tests with "no answer" status.
- Replicator (http://www.ks-soft.net/hostmon.eng/replicator/index.htm) has built-in scanners (ping scanner, port scanner, name scanner). It can make copies of predefined test(s) for each host in the network
Regards
Alex
PS: actually this forum is "Problems and Bugs". I think your topic corresponds to "Installation and configuration" or "Wish List" forums.
There are some "auto discover" options.
- when you setup Ping or TCP test a range of IP addresses (e.g. 123.123.123.1 - 123.123.123.254) rather than a single address can be specified. In this case, HostMonitor will create a separate test for each of the addresses within that range. After 1st check you may remove all tests with "no answer" status.
- Replicator (http://www.ks-soft.net/hostmon.eng/replicator/index.htm) has built-in scanners (ping scanner, port scanner, name scanner). It can make copies of predefined test(s) for each host in the network
Regards
Alex
PS: actually this forum is "Problems and Bugs". I think your topic corresponds to "Installation and configuration" or "Wish List" forums.