RMA error with one of three servers

All questions related to installations, configurations and maintenance of Advanced Host Monitor (including additional tools such as RMA for Windows, RMA Manager, Web Servie, RCC).
Post Reply
nate-boit
Posts: 33
Joined: Thu Sep 28, 2006 2:50 pm

RMA error with one of three servers

Post by nate-boit »

I am monitoring three servers on a remote network. I have a RMA installed on serverA. HostMonitor reads event logs from ServerA and ServerB, but not ServerC. I can connect to ServerC from the RMA ServerA event manager. I have a ping test using the RMA to ping ServerC and it responds fine. However, the event log test always returns back status unknown and reply of "RMA: Cannot read data."

Same domain, same subnet, can ping and terminal service ServerC from ServerA.

Any thoughts on why i am getting this error?
KS-Soft
Posts: 13012
Joined: Wed Apr 03, 2002 6:00 pm
Location: USA
Contact:

Post by KS-Soft »

"RMA: Cannot read data" means HostMonitor does not receive response from RMA within specified timeout. In turn that means RMA did not received reply from target system.
So, try to increase timeout specified for the agent http://www.ks-soft.net/hostmon.eng/mfra ... #agentlist

Regards
Alex
nate-boit
Posts: 33
Joined: Thu Sep 28, 2006 2:50 pm

Post by nate-boit »

But why for only one of the three tests? i increased the timeout to 5 minutes and still get the same error.
KS-Soft
Posts: 13012
Joined: Wed Apr 03, 2002 6:00 pm
Location: USA
Contact:

Post by KS-Soft »

This means SystemC does not respond within 5 min. Why? I don't know. There are a lot of possible reasons - antivirus, firewall, problems with RPC service, some other problem with target system... Try to install RMA on system C and reach system A and system B from there.

Regards
Alex
Post Reply