I want to allow any IP address for ‘remote management’ and ‘remote updates’……….
I now have a broadband dynamic IP, so there's the problem. Before I had DSL and static IP.
Any IP for Remote Management and Updates?
You may specify range of IP addresses for "Enable remote management from address" option.
Quote from the manual
Alex
Quote from the manual
RegardsNote: Instead of single IP address you may specify a list and/or a range of IP addresses. IP addresses in the list should be separated by comma. Dash is used to define a range of addresses. Example: "192.168.1.1 - 192.168.255.255".
Alex
Unlimited Range?
I need 'unlimited' range. So will the example below work fine.
10.0.0.1 - 254.255.255.255
10.0.0.1 - 254.255.255.255
.255
Well, that works. I would like to see a future option (check box) much like the "Accept Any Connection" you currently have.
I know it seems a bit strange using the long IP subnets, but since I'm now on a dynamic IP provider, it's the only alternative I have.
I feel it would be a nice option though, if the password protects that as well.
Cheers
I know it seems a bit strange using the long IP subnets, but since I'm now on a dynamic IP provider, it's the only alternative I have.
I feel it would be a nice option though, if the password protects that as well.
Cheers
I doubt many people need such option... and there is simple workaround.I would like to see a future option (check box) much like the "Accept Any Connection" you currently have
Every operation is password protected and all traffic to the agent is encrypted.I feel it would be a nice option though, if the password protects that as well.
Regards
Alex