Replicator - SNMP Value

vieceev · Post by **vieceev** » Thu May 03, 2007 4:09 am

Hi,
could i use a SNMP value or the Hostname automaticaly as "Testname" if i import a range of ip´s ?

Erich

KS-Soft Europe · Post by **KS-Soft Europe** » Thu May 03, 2007 4:25 am

Sorry, Replicator can not use SNMP. However, you may use "Use name scanner to select hosts with names" option to get DNS or NetBIOS names. Quote from the manual:
http://www.ks-soft.net/hostmon.eng/repl ... tm#scanner
========================
"Use name scanner to select hosts with names". With this selection scanner will add to the list of addresses only those hosts that have responded with a name (name registered in DNS or NetBIOS name for systems from a LAN). Using this scan option you have a choice of what to add to the list - the name or the address of a target system.
========================

Regards,
Max

vieceev · Post by **vieceev** » Thu May 03, 2007 4:49 am

KS-Soft Europe wrote: [...] However, you may use "Use name scanner to select hosts with names" option to get DNS or NetBIOS names. Quote from the manual [...]

You are right max, but i can choose only one Rep by, so i must decide if i want to use the Title field or the Host field. I think you can replace only 1 string which you define by "Replicate by". Must i edit each entry now ?

Erich

KS-Soft Europe · Post by **KS-Soft Europe** » Thu May 03, 2007 5:26 am

vieceev wrote:You are right max, but the TITLE is NOT filled in with this info (after import - 287 same Titels ...)

Replicator does not change TITLE because it cannot match it with "Replicate by" value. Please note, Replicator is able to replace several items in the source at once. You should change TITLE in "Source" template with the value in "Replicate by" field also.

Regards,
Max