RMA - Accept connections from IP range?

timn · Post by **timn** » Mon Dec 22, 2003 2:39 pm

Alex:

Is it possible to specify an IP range when setting the IP addresses that RMA will allow connections from?

Some of the hosts we are connecting to sit in a DMZ. All traffic from higher-security networks (i.e. the one where AHM is running) to lower security networks (i.e. where the RMA is running) are dynamically NAT'ed.

I know the IP NAT pool range but the specific IP changes dynamically.

KS-Soft · Post by **KS-Soft** » Mon Dec 22, 2003 5:13 pm

No, it doesn't support IP range

You can specify addresses one by one or disable filter.

Regards
Alex

timn · Post by **timn** » Mon Dec 22, 2003 7:34 pm

No problem -- I can work around it for time being. I think I can have the machine running AHM statically NAT'ed along the path so it always shows up at the RMA with the same IP.

It's a bit thorny since the pathway is through a PIX, then through a set of F5 Networks boxes.

I keep coming home expecting to see AHM washing the dishes and cooking supper...