Dial-up to network entries not shown

Peteravr · Post by **Peteravr** » Thu Sep 11, 2003 7:58 am

I want to configure a action profile to dial-up to a network when certain tests fail, but I cannot select any dial-up entries in host monitor, because they are not shown.
When I check in windows the dial-up entries are shown. What am I doing wrong?

KS-Soft · Post by **KS-Soft** » Thu Sep 11, 2003 11:33 am

What version of HostMonitor and Windows do you use?

Regards
Alex

Peteravr · Post by **Peteravr** » Fri Sep 12, 2003 2:26 am

I use HM version 3.71 and thios is installed on a windows2000 server with service pack 3 installed.
Tried enabling Routing and remote access but no succes. Even added entries to routing and remote access for dialing in to remote network but again no succes.

KS-Soft · Post by **KS-Soft** » Fri Sep 12, 2003 4:27 pm

Unfortunatelly we do not have Windows 2000 SP3. But I just checked HostMonitor on 3 systems: Windows 2000, Windows 2000 SP1, Windows 2000 SP4. On all these system it works fine. Probably problem related just to SP3, in this case you may install SP4
Also you can try to type name of the dial-up connection manually, HostMonitor allows that.

Regards
Alex