I have the following question.
I would like to read the percentage of the toners and when a waste toner is full.
Currently in use, the "Printer Levels" test for the percentage of toner is used, which allows me to easily set when the toner is only 1%, that it will be replaced.
(I immediately have to ask, when I set this value to 0%, does this mean that when the toner is REALLY EMPTY, does it give a message or does 0% mean that there is no value? )
But now I also want to read the Waste Toner and we use Canon.
Unfortunately, there is no percentage in the Canon portal, but the message is "nearly full".
When I use "Printer Status" in the test, I get the reply "toner is low (black). Waste toner needs to be checked".
This message is good, but I would like to only receive the Waste Toner message during the "Printer Status" test instead of the normal toner and the waste toner.
The reason is because it does not indicate a percentage for normal toner and this value is included in the "Printer Levels" test.
Thanks for contributing ideas.
Regards.
Printer Status and Printer Level test
HostMonitor cannot ignore some specific messages/alerts. It can ignore some sort of messages, like almost full and almost empty warnings.
You may use Optional status processing expressions like
Tune up Reply value [replace("%SuggestedReply%","toner is low (black).","")]
https://www.ks-soft.net/hostmon.eng/mfr ... processing
Regards
Alex
You may use Optional status processing expressions like
Tune up Reply value [replace("%SuggestedReply%","toner is low (black).","")]
https://www.ks-soft.net/hostmon.eng/mfr ... processing
Regards
Alex