Tune Up with Timeout as reply

ruzickav · Post by **ruzickav** » Tue Jan 30, 2018 2:46 pm

Hello everyone,
I have a temperature sensor connected via SNMP. Unfortunately, from time to time, connection timed out. I am using Tune Up value because of output format. Is there any way to raise BAD / GOOD action only when the reply is bigger / lower than a value (23celsius degree), but not on Timeout? Now when timed out - mail sent. Next round reply value appears as requested - mail sent. I dont want to do some action on Timeout and even on change from timeout to some value lower then limit.

Best regards
Vladimir

KS-Soft · Post by **KS-Soft** » Tue Jan 30, 2018 4:37 pm

Unmark "Treat Unknown status as Bad" option or better increase Timeout and Retries

Regards
Alex

ruzickav · Post by **ruzickav** » Wed Jan 31, 2018 2:38 am

KS-Soft wrote:Unmark "Treat Unknown status as Bad" option or better increase Timeout and Retries

Regards
Alex

Not working - action is executed (email sent), when return to "Good" status.

KS-Soft · Post by **KS-Soft** » Wed Jan 31, 2018 6:00 am

Probably "Action depends on Bad one" option is unmarked (Good action properties)?

What about Timeout/Retries parameters?

Regards
Alex

ruzickav · Post by **ruzickav** » Wed Jan 31, 2018 8:33 am

KS-Soft wrote:Probably "Action depends on Bad one" option is unmarked (Good action properties)?

What about Timeout/Retries parameters?

Regards
Alex

Bingo - thank you very much.

KS-Soft · Post by **KS-Soft** » Wed Jan 31, 2018 8:47 am

You are welcome

Regards
Alex