show only traffic values from snmp test

menno · Post by **menno** » Tue Jul 19, 2016 5:01 am

Hi team,
we have a snmp test to test the managed switch port traffic

what i want is a test that only shows the value of that snmp test ... no alert(s) are needed.

can you please tell me how to set this up ?

thx
Menno

KS-Soft · Post by **KS-Soft** » Tue Jul 19, 2016 6:15 am

Assign empty alert profile to the test

Regards
Alex

menno · Post by **menno** » Tue Jul 19, 2016 8:43 am

Alex ...
sorry maybe i was not clear enough.

i use the hostmonitor traffic monitor test
i specify the host and the snmp profile
and under check i find the portname .
...so far so good

There is an option Alert if
But i do not want any alert. i just want to see the result of the test
for example as reply : 0.5MB

i hope you can me out here
many thanks in advance
m

KS-Soft · Post by **KS-Soft** » Tue Jul 19, 2016 8:55 am

If you assign empty alert action, you will not receive any alerts.

If you mean you do not want to see "bad" test status, set condition that never met or set the following option
Use Normal status if ('%SuggestedSimpleStatus%'=='DOWN')

Regards
Alex

menno · Post by **menno** » Wed Jul 20, 2016 1:08 am

thanks
yes this worked !