Test for RMA Availability

dmuller · Post by **dmuller** » Tue Feb 19, 2008 9:24 am

I am probably being dense, but is there a way to make a test to check to see if an RMA agent is alive before running the tests connected to it?

KS-Soft · Post by **KS-Soft** » Tue Feb 19, 2008 9:29 am

You may use TCP test

Regards
Alex

dmuller · Post by **dmuller** » Tue Feb 19, 2008 11:12 am

Ok, I set up a new TCP test to the remote IP RMA port of 1055. Do I need to send data? It always shows down for all tests I set up this way even though the RMAs are up.

KS-Soft Europe · Post by **KS-Soft Europe** » Tue Feb 19, 2008 11:15 am

dmuller wrote:Ok, I set up a new TCP test to the remote IP RMA port of 1055. Do I need to send data?

No, you do not.

dmuller wrote:It always shows down for all tests I set up this way even though the RMAs are up.

I suppose, it happens because RMA's port is opened on the firewall, while other ports you specify were blocked by firewall.

Regards,
Max

dmuller · Post by **dmuller** » Tue Feb 19, 2008 11:24 am

The RMA port is 1055 for a specific RMA. THe RMA works just fine. If, however, I set up a TCP Test to port 1055 to that specific RMA, it always comes back as down.

KS-Soft · Post by **KS-Soft** » Tue Feb 19, 2008 11:28 am

Cannot reproduce the problem. What version of HostMonitor/RMA do you use? Windows? Service Pack?

Regards
Alex

KS-Soft

Test for RMA Availability

Test for RMA Availability

TCP Test

Re: TCP Test

Huh?