Tune up reply value to allow all http response codes

[gorisdean]

Hi, I'm searching for a way to make sure a URL request test evaluates to 'Host is alive' as long as any HTTP response code is received (1*, 2*, 3*, 4*, 5*).

Only if the URL request is not answered the test should go into Bad state.

I was looking into the 'Tune up reply value' functionality, but am not able to get a working evaluation with %HttpCode%.

Any suggestions?

Thanks!

[KS-Soft]

"Tune up Reply" option does not set test status, just Reply value.
You may use "Use Normal status" option.
E.g. Use Normal status if "%SuggestedStatus%"=="Bad"

If you are checking HTTP service and you just need to check that port is open, I would suggest TCP test method..

Regards
Alex