Hello,
I configured SNMP-trap to receive information from one of our Servers. Now I would like to filter the bad Status of the test by only a part of the OIDs. That would give me the ability to receive only traps which begin with 1.3.6.1.4.1.1302. I tried to use Enterprise filter, but it seems to filter by complete OIDs only. Is there any way to configure what I described?
Thanks for any hint!
filter SNMP-trap by part of OID
-
thomas.mueller@envers.de
- Posts: 34
- Joined: Mon Oct 26, 2009 2:55 pm
- Location: Duisburg, GERMANY
Yes, you may type 1.3.6.1.4.1.1302*
Quote from the manual:
--------------
You may type "any" instead of specific object identifier. In such case HostMonitor will check every object contained in the Trap message.
Also you may use trailing wildcard * for "Message contains OID" test property. E.g. 1.3.6.1.2.1.1.3*
--------------
Regards
Alex
Quote from the manual:
--------------
You may type "any" instead of specific object identifier. In such case HostMonitor will check every object contained in the Trap message.
Also you may use trailing wildcard * for "Message contains OID" test property. E.g. 1.3.6.1.2.1.1.3*
--------------
Regards
Alex