SNMP test

jromariz · Post by **jromariz** » Tue May 20, 2003 9:14 pm

Hi Alex,

Need to test the traffic in a WAN link. Using SNMP veriable I´m able to check for changes on the response value that shows if the traffic is flowing. How can I configure the test for alarm when the traffic stops flowing for more then a certain amount of time?

Thanks for helping.

Jromariz.

KS-Soft · Post by **KS-Soft** » Wed May 21, 2003 10:54 am

What about "Alert when ... increases by .." + "Reverse alert" option? I think its what you need.

Regards
Alex

<font size=-1>[ This Message was edited by: KS-Soft on 2003-05-21 10:54 ]</font>

jromariz · Post by **jromariz** » Thu May 22, 2003 6:40 am

Alex,

That solves the problem.

Thanks.

Regards,

Jromariz.