In the "TCP connection" test method I can use the %host% variable
Like this
Host: 10.1.1.10
Port: 3299
Test name: "SAP Router (%host%) Port 3299"
is resolved to "SAP Router (10.1.1.10) Port 3299"
I would like to have a variable for the %port% too. Like
"SAP Router (%host%) Port %port%"
Many thanks
I assume you are asking about variable that can be used for templates (as test property)? Then according to the manual you may use %TargetPort% variable
KS-Soft wrote:I assume you are asking about variable that can be used for templates (as test property)? Then according to the manual you may use %TargetPort% variable