How to load web page as a dead action?

[uneeeq]

I am a complete newbie to HostMonitor and need some help.


if I enter
http://update.mywebcontrolpanel.com/update.php?Command=SetHost&HostName=WWW&Zone=mydomain.com&Address=11.222.11.111&DomainPassword=password
into my browser our domain record is updated with a new IP address

I have tried to set Action Send data to TCP/UDP port with the following:

Server: update.mywebcontrolpanel.com
Port: 80
Protocol: TCP
Init packet: GET http://update.mywebcontrolpanel.com/update.php?Command=SetHost&HostName=WWW&Zone=mydomain.com&Address=11.222.11.111&DomainPassword=password

Wait for answer: 0

but this did not work, I have also tried POST or simply
Init packet: http://update.mywebcontrolpanel.com/update.php?Command=SetHost&HostName=WWW&Zone=mydomain.com&Address=11.222.11.111&DomainPassword=password


this was set as an action on bad status and did not work

what am I doing wrong?

Thanks in advance for any hints!

=== EDITED by Genie ===

I think I am getting to the bottom of this - I installed the AHM on a client machine on our home network (Winproxy) and it appears that classic http protocol works fine from a Winproxy Client Machine but TCP does not, my AHM sys log produces the following error : Error: Cannot send data to update.mywebcontrolpanel.com (TCP port 80). Host not found
But if the same
http://update.mywebcontrolpanel.com/update.php?Command=SetHost&HostName=WWW&Zone=mydomain.com&Address=11.222.11.111&DomainPassword=password

loaded into my web browser, works flawlessly and updates the IP addy in the record

Genie
PS - I have changed the actual values so the above references are for illustration only

[ This Message was edited by: uneeeq on 2003-02-15 14:45 ]

[KS-Soft]

Your network connected to the Internet thru proxy server? Of course HostMonitor cannot connect to the web server directly. When you configure action, specify address/port of the proxy server.
Also you may need to add " HTTP/1.0%0A%0A" to the request:
Server: address of your proxy server
Port: port used by proxy server
Protocol: TCP
Packet to send: GET http://your_webserver/update.php?your_parameters HTTP/1.0%0A%0A

Regards
Alex

[uneeeq]

Thank you Alex,
it worked perfect!

Genie