|
View previous topic :: View next topic |
Author |
Message |
Vanno
Joined: 08 May 2007 Posts: 7
|
Posted: Thu Nov 01, 2007 7:14 am Post subject: SNMP Trap with APC UPS |
|
|
Hi
I have all my regular SNMP tests working properly, however I am unable to get my SNMP traps working for an APC UPS. The OID is correct, but even when the UPS does go to battery, no alert is sent. I was wondering if you could look at my setup and tell me where I am going wrong.
Thanks
I have it set as 'set "Bad" status if received message satisfies:'
SNMP device is set with the UPS's IP address (Any from the following)
Trap type (generic) is set to 'Any'
Trap type (ent. specific) is set to 'Any'
Enterprise (sysObjectID) is set to 'Any'
'message contains OID' is checked with the OID 1.3.6.1.4.1.318.1.1.1.4 with the condition that it doesn't contain 2
'set "Ok" status if no "bad" trap received within 5 sec' |
|
Back to top |
|
|
KS-Soft
Joined: 03 Apr 2002 Posts: 12795 Location: USA
|
Posted: Thu Nov 01, 2007 7:57 am Post subject: |
|
|
I think 1.3.6.1.4.1.318.1.1.1.4 is not complete OID. Probably it should be "1.3.6.1.4.1.318.1.1.1.4.1.1.0" (upsBasicOutputStatus)?
If you change filter settings (disable "message contains OID" option), you will see exactly message comes from your UPS and then setup correct test settings. Also you may use IP-Tools' Trap Watcher utility for the same purpose
http://www.ks-soft.net/ip-tools.eng/mframe.htm#info.htm#traps
Regards
Alex |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|