Change status after multiple tests

Dubolomov · Post by **Dubolomov** » Thu Jun 01, 2006 10:42 am

Hello.
When i'm using "CPU Usage" or "SNMP (Get)" test the status of the host can change after one request. For example i would like to see average CPU load of remote host for a 5 minutes (one request per minute) and recieve alert only if all 5 minutes CPU load of host more then 80%. Is it possible in Host Monitor?
Thank's.

KS-Soft · Post by **KS-Soft** » Thu Jun 01, 2006 10:48 am

HostMonitor changes test status after single probe. However alert can be started after 5th probe ("Start when N consecutive bad results occur" option)

Regards
Alex

Dubolomov · Post by **Dubolomov** » Thu Jun 01, 2006 10:59 am

Yes, i already found answer. Thank's. But how set alerting after status changed to bad (after repeat action)?

Dubolomov · Post by **Dubolomov** » Thu Jun 01, 2006 11:03 am

Oh, i'm sorry. It's was a hard day... I found answer. Thank you very much.