|
View previous topic :: View next topic |
Author |
Message |
Quantum
Joined: 06 May 2004 Posts: 56
|
Posted: Fri Jul 09, 2004 9:16 am Post subject: Is there a way to make the checks a little less touchy ? |
|
|
What I want to do is to have checks double check their status before going bad.
ie
Standard check = 1 min
Error state is detected so the check goes up to every 1 seconds
is the status is still bad after 10 seconds, then alert.
Is this possible ?
Even an average over time for some of the checks would be ok.
eg, I don't want an alert every time my mail server's CPU spikes to 100% for 3 seconds, I want to know if it's been at 100% for 30 seconds or more.
Thanks
Q |
|
Back to top |
|
|
KS-Soft
Joined: 03 Apr 2002 Posts: 12792 Location: USA
|
Posted: Fri Jul 09, 2004 12:48 pm Post subject: |
|
|
Quote: | eg, I don't want an alert every time my mail server's CPU spikes to 100% for 3 seconds, I want to know if it's been at 100% for 30 seconds or more. |
Its easy, just change "Start when N consecutive Bad results occur" parameter of the action from 1 to 3 (if you perform test every 10 sec, 3*10=30 sec)
Quote: | Standard check = 1 min
Error state is detected so the check goes up to every 1 seconds
is the status is still bad after 10 seconds, then alert. |
Use one "Change time interval" action to reduce time interval when test fails and another "Change time interval" action to restore interval when test returns to good status.
But... If you have hundreds or thousands of tests, I would not recommend to use test interval = 1 sec.
Regards
Alex |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|