KS-Soft. Network Management Solutions
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister    ProfileProfile    Log inLog in 

OID for Eaton/IBM UPS Input Voltage

 
Post new topic   Reply to topic    KS-Soft Forum Index -> Configuration, Maintenance, Troubleshooting
View previous topic :: View next topic  
Author Message
RogerSpraggon



Joined: 19 Mar 2012
Posts: 59

PostPosted: Thu Oct 08, 2020 10:56 pm    Post subject: OID for Eaton/IBM UPS Input Voltage Reply with quote

I'm getting some bizarre results when I try and run "UPS Input Voltage" test for Powerware (Eaton, IBM) taken from the UPS/240v template.
It sometimes returns single phase (240v approx.) replies and other times it return three phase (415v approx.) replies.
I didn't have these issue prior to installing a new model NIC.
The system is actually a 3 phase system.
I was wondering what the OID is in this template as I haven't been able to find this anywhere and I wanted to check with Eaton if it is correct
Back to top
View user's profile Send private message
KS-Soft



Joined: 03 Apr 2002
Posts: 12791
Location: USA

PostPosted: Fri Oct 09, 2020 3:44 am    Post subject: Reply with quote

There is table, OID 1.3.6.1.4.1.534.1.3.4.1.2

Regards
Alex
Back to top
View user's profile Send private message Visit poster's website
RogerSpraggon



Joined: 19 Mar 2012
Posts: 59

PostPosted: Sun Oct 11, 2020 8:48 pm    Post subject: Reply with quote

Thank you.
Is the table somewhere that I can view?
I can open in MIB browser and can get to that value but it doesn't successfully test.


Last edited by RogerSpraggon on Sun Oct 11, 2020 9:09 pm; edited 1 time in total
Back to top
View user's profile Send private message
RogerSpraggon



Joined: 19 Mar 2012
Posts: 59

PostPosted: Sun Oct 11, 2020 8:54 pm    Post subject: Reply with quote

I've created test using that OID and it gives an "SNMP error: no such object"
Back to top
View user's profile Send private message
KS-Soft



Joined: 03 Apr 2002
Posts: 12791
Location: USA

PostPosted: Mon Oct 12, 2020 1:40 am    Post subject: Reply with quote

That's table, so use SNMP Table test method or MIB Browser (Get Table option)

Regards
Alex
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    KS-Soft Forum Index -> Configuration, Maintenance, Troubleshooting All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group

KS-Soft Forum Index