View previous topic :: View next topic |
Author |
Message |
RogerSpraggon
Joined: 19 Mar 2012 Posts: 59
|
Posted: Thu Oct 08, 2020 10:56 pm Post subject: OID for Eaton/IBM UPS Input Voltage |
|
|
I'm getting some bizarre results when I try and run "UPS Input Voltage" test for Powerware (Eaton, IBM) taken from the UPS/240v template.
It sometimes returns single phase (240v approx.) replies and other times it return three phase (415v approx.) replies.
I didn't have these issue prior to installing a new model NIC.
The system is actually a 3 phase system.
I was wondering what the OID is in this template as I haven't been able to find this anywhere and I wanted to check with Eaton if it is correct |
|
Back to top |
|
|
KS-Soft
Joined: 03 Apr 2002 Posts: 12795 Location: USA
|
Posted: Fri Oct 09, 2020 3:44 am Post subject: |
|
|
There is table, OID 1.3.6.1.4.1.534.1.3.4.1.2
Regards
Alex |
|
Back to top |
|
|
RogerSpraggon
Joined: 19 Mar 2012 Posts: 59
|
Posted: Sun Oct 11, 2020 8:48 pm Post subject: |
|
|
Thank you.
Is the table somewhere that I can view?
I can open in MIB browser and can get to that value but it doesn't successfully test.
Last edited by RogerSpraggon on Sun Oct 11, 2020 9:09 pm; edited 1 time in total |
|
Back to top |
|
|
RogerSpraggon
Joined: 19 Mar 2012 Posts: 59
|
Posted: Sun Oct 11, 2020 8:54 pm Post subject: |
|
|
I've created test using that OID and it gives an "SNMP error: no such object" |
|
Back to top |
|
|
KS-Soft
Joined: 03 Apr 2002 Posts: 12795 Location: USA
|
Posted: Mon Oct 12, 2020 1:40 am Post subject: |
|
|
That's table, so use SNMP Table test method or MIB Browser (Get Table option)
Regards
Alex |
|
Back to top |
|
|
|