|
View previous topic :: View next topic |
Author |
Message |
sfroach
Joined: 21 Sep 2009 Posts: 2
|
Posted: Mon Sep 21, 2009 7:30 pm Post subject: How to test Cable & DSL ISP uptime |
|
|
I have a small SOHO with a XC-DPG502 Twin WAN (cable & DSL) router with fall over capability. I'd like to monitor my ISP availability for cable vrs DSL.
I've reviewed the info in the forum and I can't figure out something.
1. How do I configure Host Monitor to test for this?
2. Specifically, I'd like to know when one of my ISP's goes down & up, which one (cable or DSL). I'd like to obtain the following info for each ISP: % time down, minutes down, Alive ratio, status, etc.
Tks, Steveo |
|
Back to top |
|
|
KS-Soft
Joined: 03 Apr 2002 Posts: 12800 Location: USA
|
Posted: Mon Sep 21, 2009 8:29 pm Post subject: |
|
|
XC-DPG502.. This one http://www.xincom.com/products/502/features.php?
As I see it support SNMP protocol so probably you may use SNMP Get test method to check interface status
http://www.ks-soft.net/hostmon.eng/mframe.htm#tests.htm#chkSNMP
On the other hand if DSL modem works fine while connection to ISP is dropped, may be router will not notice such problem? I don't know because we do not have such device.
Is your router connected to 2 different service providers (ISP) and it has 2 different external IP addresses? Then you may use Ping or Trace test methods to check what channel is active..
Regards
Alex |
|
Back to top |
|
|
sfroach
Joined: 21 Sep 2009 Posts: 2
|
Posted: Mon Sep 21, 2009 9:18 pm Post subject: Test for which ISP is active |
|
|
Yes, that's the one.
1. I have both cable modem & DSL modem connected to the router.
2. I will look at the SNMP Get test method info to see if I can figure out how to test for router external interface status.
3. The router switches between cable & DSL when ever the router's health check for that ISP fails. I usually have the router configured so cable is the primary and DSL is the backup. So DSL only gets enabled when cable ISP fails. With that configuration, the router switches back to cable as soon as it is back up.
4. The router has 2 external MAC addresses. So I think it must have 2 external IP addresses. I'll check. I will look into using Ping/Trace Tests to determine when one of the external IP addresses are not active.
Thanks,
Steveo |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|