Hi Alex,KS-Soft wrote:Done. The same updateProbably FailureIteration and CurrentStatusIteration should be set to 0 as well
Many thanks for the new 6.51d
I think a new thread for this question will be better - the "old" one is very complex now.
Please check that again:
I've following test that keeps Bad even if I do the following
- When you have test in Status Bad
- Change the test and Apply
- Agree to "Reset recurrences and check status now"
[x] Use "Warning" status if: ("%SuggestedSimpleStatus%"=="DOWN") and (%FailureIteration% < 10)
[x] Use "Normal" status if: ("%SuggestedSimpleStatus%"=="DOWN") and (%FailureIteration% < 5)