traffic monitor on fibre channel?

mp1 · Post by **mp1** » Wed Mar 08, 2006 9:57 am

Hi,

Is there a possibility to get the traffic monitor to work with a fibre channel interface?

It works perfect with all eth nics.

When I connect to the fibre channel switch, than I get the interface fc0 down?

Thanks in advance

Martin

KS-Soft · Post by **KS-Soft** » Wed Mar 08, 2006 12:22 pm

When I connect to the fibre channel switch, than I get the interface fc0 down?

Not sure I understand the problem. Do you mean HostMonitor displays correct information about interface but wrong status in "Choose network interface" dialog?

Regards
Alex

mp1 · Post by **mp1** » Wed Mar 08, 2006 2:02 pm

No, unfortunatelly I get no informations, because hm says that the interface is down, but the interface is definitely up.

I tested it on 4 differnt fibre channel switches. Only the eth0 - management interface will be show as up.

I can't find any special configuration for SNMP on this swicht, I mean if there a differences between the fibre channel and ethernet port.

Does anybody have experience with a fibre channel switch?

Thanks,

Martin

KS-Soft · Post by **KS-Soft** » Wed Mar 08, 2006 2:23 pm

No, unfortunatelly I get no informations, because hm says that the interface is down, but the interface is definitely up.

Still do not understand. If HostMonitor cannot retrieve information, it does not say "interface is down".
Could you please send screen shot to support@ks-soft.net

Regards
Alex